5 Axis Homing using CoreXYUV

For readers of this blog who don’t know, I have what is essentially a dual CoreXY printer with two CoreXY mechanisms stacked one above the other. The lower gantry carries the hot end and the upper gantry carries the 5 E3D Titan extruders. This enables me to use much shorter Bowden tubes than I would […]

Some minor printer upgrades

As readers of this blog will know, the upgrade to 5 colour was done in a bit of hurry in order to get the printer ready for the TCT show. There were a few things that I wasn’t entirely happy about so I’ve been putting those things right, as well as making a couple of […]