Upgrading my Extruders from 5 E3D Titans to 5 Bondtech BMGs

Following my extreme retraction torture tests, I decided to upgrade my printer from using E3D Titan extruders to BondTech BMGs (five of them). This was quite a major job for many reasons and because………..well, on the basis that a picture is worth a thousand words, then a video must be worth more, so in the […]

5 reel anti tangle filament holder upgrade

This was my original method for holding filament Essentially two lengths of 2020 vslot extrusion spanning the width of the printer. Cylindrical adaptors (printed parts) of about 45mm diameter with a square hole right through the middle and with flanges at one end, were slid over the rods. Filament was loaded by sliding the reels […]