Tag: Filament spool holder

Written by deckingman

Dynamic force cancellation\load balancing.

Sub title – My crazy printer is now completely insane!   As followers of this blog will know, for various reasons, the moving mass of my printer is in the order of 4.2Kgs in the Y direction. That in itself isn’t an issue because I have demonstrated that I can print at up to 300mm/sec […]

Written by deckingman

5 reel anti tangle filament holder upgrade

This was my original method for holding filament Essentially two lengths of 2020 vslot extrusion spanning the width of the printer. Cylindrical adaptors (printed parts) of about 45mm diameter with a square hole right through the middle and with flanges at one end, were slid over the rods. Filament was loaded by sliding the reels […]